[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] multicast
Baskar,
Set up the MAC address table on the switches statically to send traffic going to the common MAC address to all firewall ports. The commands to do this are: <login to the switch> enable <give enable password> configure terminal mac-address-table static 0901.0203.0405 fastEthernet 0/4 fastEthernet 0/1 fastEthernet 0/2 fastEthernet 0/3 mac-address-table static 0901.0203.0405 fastEthernet 0/5 fastEthernet 0/1 fastEthernet 0/2 fastEthernet 0/3 mac-address-table static 0901.0203.0405 fastEthernet 0/6 fastEthernet 0/1 fastEthernet 0/2 fastEthernet 0/3 exit The commands above tell that whenever a packet comes in from ports 4-6 and is going to MAC address 9:1:2:3:4:5, send it to ports 1-3. You can do this with both unicast and multicast addresses, and this functionality exists even in the base IOS. When you have exited configure mode, you can check the MAC address table with: show mac-address-table I hope this helps,
----- Original Message -----
From: "Baskar Pathmanathan" <[email protected]>
To: <[email protected]>
Sent: Monday, September 25, 2000 10:12
PM
Subject: [FW1] multicast > Hi, > > I am trying to get a stonebeat fullcluster running with no luck. I realise > that that the switch I am using( Cisco 2924 XL) needs multicast to be > enabled. How do I go about doing this, on the switch. > > thanks > baskar > > > ================================================================================ > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================================================ >
|