[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW1] Problems after upgrade from 4.0 to 4.1
Title: Problems after upgrade from 4.0 to 4.1 Hi, I have a problem installing a policy from a management station to a firewall module after I've upgraded both of them from 4.0 to 4.1. The upgrade was done from 4.0 SP5. This is some of the results I have: Output from a policy install via the firewall gui (4.1):
test6.W: Security Policy Script generated into test6.pf
Downloading Security Policy /opt/CPfw1-41/conf/test6.pf to pandora
Installing Security Policy /opt/CPfw1-41/conf/test6.pf on all.all@pandora
Installing Security Policy on pandora failed Done ---------------------------------------------------------- An fw fetch on the firewall gateway gives the following output:
pandora # fw fetch master
---------------------------------------------------------- No security policy gets loaded when doing the above. When I do a fwstop;fwstart on the firewall gateway it manages to get test6_ver40.pf from the management station. Now the 4.1 firewall has got a 4.0 policy installed and is working fine. I have completely removed and reinstalled the firewall software on the firewall module without success. I haven't yet done so on the management station. Is there perhaps a problem with the config files? What is this "Multiple type for table are illegal" message? The management station: SparcStation 5 128MB RAM
Rulebase: 28 Rules
Any suggestions? Any seen this before? Thanks
|