[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] Address Ip Range
IP Range objects can only be used in NAT rules...they can not be used in your Security Policy rule base... you can make a range using the Network Object object...or make workstation objects and put them in a group... Anyone have any better ideas?... -----Original Message----- From: Mohamed HAMOUCH [mailto:[email protected]] Sent: Sunday, December 31, 2000 1:08 PM Cc: [email protected] Subject: [FW1] Address Ip Range hello All, is there anyway of creating a range of IP addresses? When I try to add an objetct of range Ip addresses that i created ,I couldn't see it among the Network Objects. Mario Kadastik wrote: > Hello All > > Is it possible to create a port range ? > I'd like to allow to ports from 20000 -> 21000 > but can't see an object that would allow doing it ... > > Mario Kadastik > [email protected] > > ============================================================================ ==== > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ============================================================================ ==== -- Mohamed HAMOUCH E-mail:ham at iav dot ac dot ma I.A.V Hassan II (Rabat, Capital of Morocco) ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|