NETWORK PRESENCE ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT
 


Search
display results
words begin  exact words  any words part 

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[FW1] adding remote module



Hi guys,

After have to install a few remote modules and not being able to actually
define the proper steps I have a few points to clear.

In the management station, does the file fw/conf/clients  have to contain my
remote module cause I had an installation were a remote module was installed
and active and it did not appear in the clients file so I understood that it
does not actually use this file but the definition of an internal module of
the object + the putkey.

I  do not have stop the management station in 4.1 in order to add a remote
module, true ??

Does the file fw/conf/serverkeys  in my management suppose to contain all my
modules too ??

Am I suppose to add the module first using cpconfig and issue putkey before
defining it in the gui ?

Idan


================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================



 
----------------------------------

ABOUT SERVICES PRODUCTS TRAINING CONTACT US SEARCH SUPPORT SITE MAP LEGAL
   All contents © 2004 Network Presence, LLC. All rights reserved.