[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] Authentication for command fetch failed
Check out the 43 ways to to a putkey at Phoneboy: http://www.phoneboy.com/fw1/faq/0038.html Cheers! -john -----Original Message----- From: Velasquez Venegas Jaime Omar [mailto:[email protected]] Sent: Friday, January 26, 2001 12:42 PM To: FW1-MailingList (E-mail) Subject: [FW1] Authentication for command fetch failed Trying to install FW-1 on a Distributed Mode , we have this *typical* scenario: [M.Module] ------[FW-1] --------[Internet] Suppose M.Module and one of FW-1 Interfaces are on the trusted zone. M.Module is doing NAT to a valid ip address too. On M.Module , after Managament Module installation we did: Remote Modules: [Interface on Trusted Zone of FW-1] fw putkey [Interface on Trusted Zone of FW-1] On FW-1 Module , after Firewall Module installation we did: fw putkey [Interface on trusted zone of M.Module] However , when we start fw-1 service on FW-1 , we get this error: Authentication for command fetch failed Fetching security policy from [Interface on trusted zone of M.Module] failed! How can i fix this? Also , are those fw putkey ok? and yes both workstations can *see* each other Jaime O. ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|