[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] FW's constantly changing state
Mike: Do you have at your disposal a sniffer? If not, try and run tcpdump on your FWs and look for Multicast traffic. If you see someone sending Multicast broadcast traffic on any of the networks that are connected to your Nokia's this would be the cause. Have you placed any new network equipment on your network? Hope that this helps. Let me know. MikeCC <[email protected]> on 01/29/2001 09:42:40 AM To: [email protected] cc: (bcc: James E Clukey/Rush/RSH) Subject [FW1] FW's constantly changing state : Hello, I am running two Nokia 650's with FW 4.1 running VRRP. The issue I am having is that every couple of minutes both firewalls change state, from installed to disconnected and back from disconnected to installed. When I look at the VRRP status, both firewalls think they are the master. The firewalls are connected for a Cisco 6509 switch, but I have since put them on a simple hub and still see the same behavior. Any suggestions? MikeCC http://atrek.org/mikecc ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================ ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|