[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] FW's constantly changing state
Do you have a rule that allows for VRRP traffic to pass between the two modules? If not, that will definately cause a big problem for you. Through Voyager, go to the Checkpoint FireWall-1 options and turn off the "run ifwd to monitor interface changes". What version of IPSO are you running? -Jeff -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of MikeCC Sent: Monday, January 29, 2001 10:43 AM To: [email protected] Subject: [FW1] FW's constantly changing state Hello, I am running two Nokia 650's with FW 4.1 running VRRP. The issue I am having is that every couple of minutes both firewalls change state, from installed to disconnected and back from disconnected to installed. When I look at the VRRP status, both firewalls think they are the master. The firewalls are connected for a Cisco 6509 switch, but I have since put them on a simple hub and still see the same behavior. Any suggestions? MikeCC http://atrek.org/mikecc ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|