Re: [FW-1] Nokia IP110 & IPSO update

[Sheri Dougherty <sdougherty@FW1-NOSPAMCORP.ATTCANADA.CA>]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

You might want to check on the Nokia site before doing this....I'm
not aware of a boot manager upgrade being
required for IP110's...I know that the 300 and 600 series do, when
upgrading to 3.4.1....

I also would ensure the new package is running correctly before
deleting old packages, in case you need to
revert to the older image....

Sheri Dougherty
Security Integration Analyst
work:cell:email:   sdougherty@corp.attcanada.ca



- -----Original Message-----
From: Juan Concepcion [mailto:juanconcepcion@EARTHLINK.NET]
Sent: Tuesday, October 30, 2001 6:15 AM
To: FW-1-MAILINGLIST@beethoven.us.checkpoint.com
Subject: Re: [FW-1] Nokia IP110 & IPSO update


Hopefully you upgraded the boot manager before you did the ipso,
otherwise you
corrupted your installation.  The only remedy, and someone correct me
if I'm
wrong, would be to delete the initial file for that install under
Voyager,
delete the 3.4.1 package and then re-do the install the correct way,
upgrading
the boot manager first, and then the ipso, in this manner you get the
correct
initial file created.



Thomas Nilsen wrote:

> Since there seem to be no explicit malinglist for the Nokia IP
> hardware I'll try to post this here...
>
> We've just tried to upgrade a Nokia IP110 with the IPSO 3.4.1
> release (from 3.3.3). After the upgrade, the box no longer boots
> properly. During boot, it will fail to load he boot manager (just
> stops after "Loading
> bootmanager.....")
>
> As I kept the old IPSO image it is possible to boot the box using
> the old kernel image. However, as Checkpoint 4.1 SP5 requires the
> new IPSO image, we are quite lost as to what we need to do (Nokia
> want to charge us $1000 to solve the issue)
>
> During the IPSO install, a new boot manager was installed. (No
> document on Nokia suggests that a new boot manager was required for
> this release on the IP110 platform).
>
> Anyone had the same problem?
>
> Booting on the new IPSO image, will produce an output like this:
>
> [kernel] symtab c040c000, sym_start c040c004, sym_end c0442e5c
> [kernel] sym_size 4932, str_size 4d6ec
> [ preserving 0x84548 bytes of kernel symbol table ]
> Copyright (c) 1982, 1986, 1989, 1991, 1993
>         The Regents of the University of California.  All rights
> reserved.
>
> Resizing packet buffers: mbufs 15360 clusters 7680
> releng 826  08.18.2001-053000
> CPU: 267-MHz Pentium (586-class CPU)
> real memory  = 67108864 (64M bytes)
> avail memory = 57192448 (54M bytes)
> mediagx0 <Cyrix GXLV CPU with PCI/Memory Controller> rev 0 on
> pci0:0:0 mediagx1 <Cyrix CS5530 PCI to ISA bridge> rev 0 on
> pci0:18:0
> mediagx2 <Cyrix CS5530 SMI> rev 0 on pci0:18:1
> mediagx3 <Cyrix CS5530 IDE> rev 0 on pci0:18:2
> Probing for devices on the ISA bus:
> sio0 at 0x3f8-0x3ff irq 4 on isa
> <5>sio0: type 16550A
> sio1 at 0x2f8-0x2ff irq 3 on isa
> <5>sio1: type 16550A
> wdc0 at 0x1f0-0x1f7 irq 14 on isa
> wdc0: unit 0 (wd0): <IBM-DJSA-205>, LBA
> wd0: 5000MB (9767520 sectors), LBA geometry: 608 cyls, 255 heads,
> 63 S/T wd0: Physical geometry: 10336 cyls, 15 heads, 63 S/T
> npx0 on motherboard
> npx0: INT 16 interface
> superio0 at 0x0 on isa
> SEEPROM revision: actual=1, latest=2
> mediagx4 <Cyrix CS5530 audio> rev 0 on pci0:18:3
> fxp0 <Intel EtherExpress Pro 10/100B Ethernet> rev 9 int a irq 6
> slot 1 netlog:eth-s1p1 .. Ethernet address 0:a0:8e:20:8:a7
> fxp1 <Intel EtherExpress Pro 10/100B Ethernet> rev 9 int a irq 10
> slot 2 netlog:eth-s2p1 .. Ethernet address 0:a0:8e:20:8:a8
> fxp2 <Intel EtherExpress Pro 10/100B Ethernet> rev 9 int a irq 11
> slot 3 netlog:eth-s3p1 .. Ethernet address 0:a0:8e:20:8:a9
>
> Best Regards,
> Thomas Nilsen
> Kverneland IT AS
> Phone: +47 5142 9463 - Mobile: +47 991 55 001
>
> ===============================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> ===============================================

===============================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
===============================================

-----BEGIN PGP SIGNATURE-----
Version: PGPfreeware 6.5.8 for non-commercial use <http://www.pgp.com>

iQA/AwUBO96yPJhMw/5HjIWhEQLjyQCaAkKKkYuQImJtuHNWdu0On4JO6cEAoPZq
bFWKzPXMZrHkSe5M14XKaJiv
=J/y5
-----END PGP SIGNATURE-----
-----
This message was scanned by AT&T Canada IES (Security Provisioning) for
viruses. This protection does not ensure this message is virus free, however
every precaution possible has been taken on our part.

===============================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
===============================================