| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [FW-1] multiple outside connections
- To: [email protected]
- Subject: Re: [FW-1] multiple outside connections
- From: Kevin Martin <[email protected]>
- Date: Thu, 28 Feb 2002 16:54:23 -0600
- Reply-to: Mailing list for discussion of Firewall-1 <[email protected]>
- Sender: Mailing list for discussion of Firewall-1 <[email protected]>
- Thread-index: AcHAmekwjFxW+kQZQze1uw2Ql47+gwAEe0Mw
- Thread-topic: [FW-1] multiple outside connections
Just setup the routes to the private link to go to the correct router
(the private link router) and it's done. Once the firewall receives the
reply packet it will know to translate back to the private link and send
it back out if the routing is correct. Do you even have to do nat
though if the dmz's (I'm assuming that's what the private link and the
internet connections are touching) have the firewall as their default
route?
kevin
-----Original Message-----
From: Gijs Wuyts [mailto:[email protected]]
Sent: Thursday, February 28, 2002 2:45 PM
To: [email protected]
Subject: [FW-1] multiple outside connections
Hi,
this is the setup,
1 FW-1NG on Sol8, with 4 inside dmz's, 1 outside to the Internet
(default gateway), and 1 outside to another ip link, a private network.
All connections should go back to the Internet, but customers entering
through the private link should get their responses back through that
link. They access the sane resources, but I'd neet to NAT the same
object twice. Possible?
Gijs
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
=================================================
To set vacation, Out Of Office, or away messages,
send an email to [email protected]
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
[email protected]
=================================================
|
|
