[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] How to make a rule to allow telnet to the firewall?
Thank you so much for your advice. Lars.Troen> I guess you should put the Checkpoint cd in your pc and go to the "/Docs/Check Point Suite/" directory. I guess the document "Getting Started.pdf" would be a good starting point, but there are also other useful documents in there ;-) Aaron.Reynolds> You should run the GUI to modify rules. Yes, I am reading it and have succeeded in telneting the FW-1 from a internal LAN which has the same network address with FW-1. But I could not telnet the FW-1 from a internal LAN which has a different network address with FW-1 yet. The two internal LAN are connected to each other by a router. The rule was made as follows, No SOURCE DESTINATION SERVICE ACTION TRACK INSTALL ON TIME 1 *Any FW-1 telnet accept Log FW-1 *Any FW-1 is in the network 192.168.20.0 and my client box is in the network 10.8.46.0. >From my client box, $route -n 192.168.20.0 10.8.46.212 255.255.255.0 UG 0 0 0 eth0 10.8.46.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo 0.0.0.0 10.8.46.254 0.0.0.0 UG 0 0 0 eth0 How to set a rule to allow my client from the network 10.8.46.0 to telnet the FW-1 in the network 192.168.20.0? Thank you so much for your consideration! Best regards, --Wen ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|