[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW-1] RSH and FW-1 4.1 SP6
Mark Pace Balzan wrote: > > Hi All, > > im having problems with rsh through the firewall (yes im aware rsh is not > the best security practise) > > Setup: FW-1 4.1 with SP6 on SPARC Solaris 7 32bit > > I have an rsh client and rsh server running on linux. when these are > connected on the same subnet, rsh between the two works perfectly well. > > when i place the firewall between the two, everything works as expected, > except for rsh connections, that are either very slow (up to and over a > minute to respond), or doesnt work at all. telnet/ssh etc.. to both linux > boxen works ok > > i initially put a rule on my fw: > src: client dst: server service: rsh(tcp 514) action: accept track: > long > > In the logs i see the request going from client to server as accepted > I then see dropped traffic from the server back to the client. > > Should I being seeing this at all in the logs ? Yes. > Am I wrong in thinking that the firewall should track the state of the rsh > connection, and recrdo it in the state table, like it does for other traffic > ? Yes and no. > (Yes I enabled RPC Control in Policy -> Properties ...) rsh is not an RPC service. This is has no bearing on the issue. Like FTP and other protocols from hell, rsh uses a secondary connection going from the server back to the client. In the rsh case, it is set up to carry stderr. IIRC, Check Point 4.1 has a "Property" about enabling this "RSH/REXEC stderr" connection. Make sure this is enabled. If it is not, then one would expect to see the problems you are having. -- Crist J. Clark [email protected] Globalstar CommunicationsThe information contained in this e-mail message is confidential, intended only for the use of the individual or entity named above. If the reader of this e-mail is not the intended recipient, or the employee or agent responsible to deliver it to the intended recipient, you are hereby notified that any review, dissemination, distribution or copying of this communication is strictly prohibited. If you have received this e-mail in error, please contact [email protected] ================================================= To set vacation, Out Of Office, or away messages, send an email to [email protected] in the BODY of the email add: set fw-1-mailinglist nomail ================================================= To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================= If you have any questions on how to change your subscription options, email [email protected] =================================================
|