This will simply use FW-1 connection (and password based in fw putkey) to communicate.
On Command line you can check:
fw stat remote-fw
Rajeev
Graham Leggett wrote:
Hi all,I have set up a brand new management module station to replace an aging
v4.0 instllation. I need however to check whether this new management
module will talk to our existing v4.0 remote module.So far the only way to do this seems to be to try and install a security
policy on the remote module - if things go wrong, it could take out our
firewall. Yuck.Is there a non destructive "check if all comms are ok" button in the GUI
that will confirm that the remote module and the management module can
talk to each other with the correct authorisation, etc?Regards,
Graham
--================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
-- ******************************************************************** Rajeev Kumar ([email protected]) http://www.rajeevnet.com ********************************************************************================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================