[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] Checkpoint HA configuration
Have you tried doing the cphaprob -i -e list this way you can see your registered devices which allows you to see the Device name that your cpcha is registered to and the state in which the device is in and last time it was reported. Reason im asking is if your cpha is registered to fwd, you might want to kill -HUP and see if the state changes. Also you might want to make sure you run your cphaprob -a if and make sure your interfaces are secured and talking. --Hope this helps --Michael -----Original Message----- From: eric [mailto:[email protected]] Sent: Tuesday, September 19, 2000 2:01 AM To: 'fw-1-mailinglist@lists. us. checkpoint. com (E-mail)' Subject: [FW1] Checkpoint HA configuration Gurus, Hello. I am having some trouble with Checkpoint's HA. I set everything up and it seems to follow the recommended config. But, when I perform a cphaprob state it shows as one active and one in initializing mode. Never seems to change. Any hints on this or documentation someone can point me to? eric. ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|