[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] Checkpoint HA configuration
The cphaprob -i -e list returns: Registered devices: Device name: sync & filter Resitration number: 0 Timeout: none Current state: initializing Time since last report: 961.1 sec Device name: fwd Registration number: 1 Timeout: 2 sec Current state: ok Time since last report: 0.5 sec The cphaprob -a if returns that hme0 is up (secured) this is the one linking the other module. It is all running on solaris 7. Each Ultra10 has the hme0 port secured and the remaining ports are on a Quad card and I mirrored the macs/ip as described. The management server is a sparcstation 5 and all can ping each other. Is there any decent docs on this? I tried following the ones Checkpoint provides but they are pretty vague. Thanks in advance. eric. -----Original Message----- From: [email protected] [mailto:[email protected]]On Behalf Of Michael Hernandez Sent: Tuesday, September 19, 2000 9:33 AM To: 'eric'; 'fw-1-mailinglist@lists. us. checkpoint. com (E-mail)' Cc: Alex Naples; David Hove; Chuck Orde; Chris Trautwein Subject: RE: [FW1] Checkpoint HA configuration Have you tried doing the cphaprob -i -e list this way you can see your registered devices which allows you to see the Device name that your cpcha is registered to and the state in which the device is in and last time it was reported. Reason im asking is if your cpha is registered to fwd, you might want to kill -HUP and see if the state changes. Also you might want to make sure you run your cphaprob -a if and make sure your interfaces are secured and talking. --Hope this helps --Michael -----Original Message----- From: eric [mailto:[email protected]] Sent: Tuesday, September 19, 2000 2:01 AM To: 'fw-1-mailinglist@lists. us. checkpoint. com (E-mail)' Subject: [FW1] Checkpoint HA configuration Gurus, Hello. I am having some trouble with Checkpoint's HA. I set everything up and it seems to follow the recommended config. But, when I perform a cphaprob state it shows as one active and one in initializing mode. Never seems to change. Any hints on this or documentation someone can point me to? eric. ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|