[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: [FW1] NAT
Your subnets will talk to each other if you configure a rule in your FW to
allow it. It�s not neccesary to configure NAT.
-----Mensaje original-----
De: Ed Rolison [mailto:[email protected]]
Enviado el: Jueves, 08 de Marzo de 2001 09:54 a.m.
Para: [email protected]
Asunto: Re: [FW1] NAT
>I have a IP 330 appliance and I have 192.168.9.X configured on one
interface
>and 192.168.15.X configured on the other. Do I have to add a nat rule to
>allow these two subnets to talk to each other or do they talk to each other
>by default since they are behind the same gateway that is protecting them??
>I thought that the external interface was the place where packets were
>dropped or accepted.
This is what routing tables are all about. And packet forwarding.
TCP/IP Network Administration by O'Reilly is quite a good book.
--
Ed Rolison
Systems Admin
ER706-RIPE
[email protected]
============================================================================
====
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
============================================================================
====
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================