[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] cannot get address of host
Eduardo, Did you check if you have in the hosts file the name and IP address of the FW Object? * In NT in the hosts file. or * In Nokia in Host Address Asigment. Hope this helps! Tchau! Matias [email protected] Enviado por: Para: [email protected] [email protected] kpoint.com cc: Asunto: [FW1] cannot get address of host 31/05/01 12.21 Good afternoon. Hi all, I´m receiving the message listed below when I´m installing my security police. I would like to found the source of this warning. Does anybody have any ideas about this ? Thanks in advance. XXXX.W: Security Policy Script generated into XXXXpf x: "C:\WINNT\FW\conf\XXXXpf", line 111: WARNING: cannot get address of host <xx> "C:\WINNT\FW\conf\XXXXpf", line 111: WARNING: will not create a value table for <target_listxx> Compiled OK. Installing Security Policy C:\WINNT\FW\conf\XXXXpf on all.all@XX Installing Security Policy on XX succeeded "A presente mensagem tem objetivo meramente informativo e não constitui obrigações ou responsabilidades das empresas integrantes do Grupo Safra". ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================ ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|